RevPi Connect+ feat. Codesys

The RevPi Connect+ feat. Codesys includes a licensed multicore capable CODESYS Control runtime system. Apart from that this RevPi Connect+ has the same hardware features as the normal RevPi Connect+ 16GB. ( Item number: 100303)

powered by Raspberry Pi CM3
2 x USB A / 2 x RJ45 Ethernet / 1 x Micro HDMI / 1 x Micro USB / 1 x RS485
Multicore CODESYS Control runtime pre-installed & licensed

Vraag direct een offerte aan!

RevPi Connect+ feat. Codesys

Neem contact op voor de actuele levertijden.

Forum Tutorials Request more information

Housing dimensions (H x W x D)	96 x 45 x 110.5 mm
Housing type	DIN rail housing (for DIN rail version EN 50022)
Housing material	Polycarbonate
Weight approx.	197 g / 224 g (incl. connectors)
IP Code	IP20
Power supply	12-24 V DC -15%-/ +20%
Max. power consumption	20 Watt (incl. 1 A total USB output current) 1)
Operating temperature	-40 °C....+55 °C 2)
Storage temperature	-40 °C....+85 °C
Humidity (at 40°C)	93% (non-condensing)
Interfaces	2 x USB A (Total current draw from both sockets max. 1 A) 3)
	2 x RJ45 10/100 Ethernet (using separate MAC addresses)
	1 x RS485 screw-type terminal (not galvanically isolated)
	1 x Micro-USB (solely for image transfer to eMMC)
	1 x Micro HDMI
	1 x PiBridge system bus
	1 x ConBridge system bus
Connectors	1 x 4-pole screw-type terminal for relay contact and signal input
	1 x 8-pole spring clamp connector for power supply
Processor	Broadcom BCM2837 quad-core ARM Cortex A53 (ARMv8)
Clock rate	1.2 GHz 2
Processor cooling	Passive with heat sink
RAM	1 GByte
Flash memory	16 GByte
1)	The average power consumption without USB load varies greatly and depends on the use of the interfaces, the GPU and the CPU. It is usually well below 4 watts without HDMI.
2)	There should be no cutbacks of power at ambient temperatures below 20°C. At 25°C ambient temperature 3 cores may run with full clock speed while with 4 cores the clock frequency is lowered from 1.2 to 1.1 GHz after 10 to 20 minutes of full stress. At 40°C ambient temperature 4 cores under full stress will still work with 1 GHz while stressing just 1 core results in no down clocking. At 50°C ambient temperature 4 fully stressed cores are running at average 0.7 GHz, having short down clockings to 0.6 GHz and short up clockings to 0.9 GHz. 1 core under full stress does result in no down clocking. At 65°C ambient temperature and either 4 or 1 core under full stress results in an “emergency mode” with just 0.4 GHz, after longer periods even 0.3 GHz.
3)	1 A USB output current (total of both USB outputs) is only available for input voltages >11 V. The bridging time of at least 10 ms required by EN 61131-2 is only guaranteed with a 20.4 to 28.8 V power supply. With a 12 V power supply, this time is significantly reduced, especially when power is drawn from the USB ports.